1. The service size is determined by the amperage and voltage ratings of the service.
True
False

2. A 120-volt circuit uses a black and red wire.
True
False

3. Is the service drop overhead or underground?
Overhead
Underground

4. All service entrance conductors must be in a conduit?
True
False

5. Implications of an undersized service include:
a. Shock hazard
b. Fire Hazard
c. Shock and Fire Hazard
d. Melting Insulation
e. Nuisance tripping of the main fuses or breakers

6. Wiring or plumbing pipes in supply ducts are?
a. Acceptable
b. Unacceptable

7. Does condensate leakage out of the induced-draft fan  housing cause corrosion problems with the primary heat exchanger?
Yes
No

8. What is the typical life span for a convention gas furnace?
a. 5 to 10 years
b. 10 to 15 years
c. 15 to 20 years
d. 20 to 25 years
e. 25 to 30 years

9. Sump pumps must discharge to a sanitary sewer?
True
False

10. Does a toilet need to have a shut off valve on the supply line?
Yes
No

11. What is the minimum width of space needed for a toilet installation?
a. 18 inches
b. 22 inches
c. 26 inches
d. 30 inches
e. There is no minimum requirement

12. How far from the tub should the electric controls be?
a. 1 foot
b. 2 feet
c. 3 feet
d. 4 feet
e. 6 feet

13. Is there a built-in cross connection in a whirlpool bath?
Yes
No

14. Do all wood stoves have firebrick in the combustion chamber?
Yes
No

15. Which type of creosote is the more serious fire hazard?
a. Black and shiny
b. Dark brown and fluffy

16. Factory-built fireplaces do not have  a smoke shelf.
True
False

17. A home inspection includes an analysis of the quality of chimney draw for a fireplace.
True
False

18. Basement fireplaces typically draw better than first or second floor fireplaces because the chimney is taller.
True
False

19. Footings most likely to settle are
a. Footings that were poured at the same time as the house foundation
b. Footings that were provided sometime later.

20. Copper pipe does not rust.
True
False

21. Welded steel piping is permitted as a material in drain, waste and vent systems.
True
False

22. Pipe size should always increase as you move downstream and more fixture join in.
True
False

23. Nearly horizontal vent pipes should slope slightly down away from the trap they are protecting.
True
False

24. The vent diameter must be as large as the trap diameter.
True
False

25. At least how far should an outdoor vent termination be above an operable door?
1. 1 foot
b. 2 feet
c. 3 feet
d. 4 feet
e. 5 feet

26. What is the typical vent size on a sewage ejector pump?
a. 1.25 inches
b. 1.5 inches
c. 2 inches
d. 2.5 inches
e. 3 inches

27. All  of these may be floor functions except:
a. transferring live and dead loads to the foundation
b. Providing lateral support for foundation walls
c. Carrying the weight of masonry chimneys

28. Columns transfer live and dead loads:
a. from joints to footings
b. from beams to footings
c. from joists to soil directly
d. from subfloors to joists
e. From subfloors to footings

29. Beams rest on:  (Two answers)
a. foundations
b. columns
c. studs
d. joists
e. buttresses

30. Where is the rust most likely to be found on a steal beam?
a. the top
b. the end
c. the middle
d. in the web only

31. Joists may sit on top of beams or be attached to the sides of beams.
True
False

32. Checking of wood beams: (two answers)
a. indicates failure
b. requires repair, but not replacement
c. Results from drying
d. Is usually not serious
e. Indicates fire damage

33. Automatic garage door openers have to be strong because they lift the weight of the door.
True
False

  --

Answers to home inspection questions:

1. True
2. False
3. Overhead
4. False
5. E
6. B
7. No
8. D 20-25 years
9. False
10. Yes
11. A 18 inches
12. C
13. Yes
14. No
15. A
16. True
17. False
18. False
19. B
20. False
21. False
22. True
23. False
24. False
25. C
26. C
27. C
28. B
29. A, B
30. B
31. True
32. C, D
33. False